Team Blacksheep CROSSFIRE Micro TX Quick Start Manual

Quick-Start Guide - TBS CROSSFIRE Micro TX
The CROSSFIRE Micro TX has a standard JR-form factor and works with any radio that supports PPM-
stream and/or TBS CRSF-format output. Transmitter power is selectable between 25mW and 100mW, and
TX status is shown using a RGB LED lite behind the push button. Frequency band 868 MHz and 915 MHz
are supported.

Push button functionality

If there is no link (LED pulsing orange
• Long press: Toggle frequency between 868 MHz and 915 MHz. Once changed it will blink white 1x
for 868 MHz and 2x for 915 MHz.
• Short press: Enter bind-mode (LED blinking green
If the receivers needs to be updated it will start blinking blue
to confirm. The update will start and the LED will be solid blue
complete. Once update is complete the LED will turn solid green
If there is a link (LED solid green
• Long press: Set failsafe
Configuration of the internal settings (region, output power, dynamic power, and operation mode) and
receiver configuration (output mapping, channel mapping ect. ) is done via any remote supporting CRSF
(TBS TANGO, OpenTX ect.) remote. The TBS CROSSFIRE Micro RX V2 comes with CH1: PPM, CH2-CH4 PWM
default settings.
):
▀ ▀ ▀ or orange ▀ ▀ ▀
1
).
▀ ▀ ▀
(■ ■ ■ ■
(▀ ▀ ▀ ) until the update is
(▀ ▀ ▀
):
Revision 2017-08-23
). Press the button again
) or orange (▀ ▀ ▀ ).