Standard/ Lite Tx Shortcut; Failsafe Test - Team Blacksheep CROSSFIRE Manual

Standard/ Lite Tx shortcut
For these two transmitters you can run a shortcut to set the failsafe position:
- Set the sticks and switches in the position you want them
- Push the joystick down
- Push and hold it up for a few seconds
- Failsafe Set​ will appear
Failsafe test
When you have set up or changed the failsafe behavior, it's important to test the correct function on the
ground. To test it:
1. Remove the propeller of your aircraft
2. Power up the radio and the model
3. Arm the model (with fc) or move your sticks in to certain position (no fc)
4. Shut down your radio
5. Depending on the failsafe type and model, check if the behavior is correct
25