Failsafe Setup; General Setup; Cut; Failsafe Position - Team Blacksheep CROSSFIRE Manual

Failsafe setup
The TBS Crossfire supports two failsafe behaviors: cut and failsafe position. Setting them up correctly is
crucial for the safety of your model.
General setup
The failsafe setting is located in the receivers menu. To change the behavior:
1. Navigate in the receiver menu by your radio/ Lua script/ Agent X
2. Open the General menu
3. Change the FS. Mode setting to what you need it to be
Cut
This is the setting that you need to use if you got a flight controller in your aircraft, that handels a failsafe
routine like RTh for you. If the link breaks up, the receiver will output no signal, which will be detected by
your fc.
Failsafe position
If you use a model without fc or with a fc that requires a special stick position (e.g. DJI NAZA) ,
failsafe-position is what you need.
With this setting, the receiver will output a previously teached position for all channels.
Important:
If you have set up failsafe position and did not teach a position afterwards, the receiver will output the last
position before the link broke up.
Teaching a position
This may require the help of a second person, as it can be tricky to hold the sticks and hit the teach button.
1. Power up your bound receiver and your radio with the crossfire transmitter in it
2. Open your ​ t ransmitter ​ m enu
3. Hold the sticks and switches in the position you want them to be in a failsafe situation
4. Click on ​ S et fs. Mode and wait for the confirmation for the set position
If your failsafe setting was set to cut and you entered the teaching mode, the crossfire will change the type
to position if you accept the request.
24