To Change The Frequency Band; Region Settings - Team Blacksheep CROSSFIRE Manual

You can choose between several frequencies:
Frequency Frequency
Setting
868 868 MHz
915 915 MHz
868CE 868 MHz, LBT technique
915FCC 915 MHz
868 Race 868 MHz
915 Race 915 MHz
868CE/ 915FCC: ​ s ame as CE/ FCC mode but with no limitations in the power level etc
868 Race/ 915 Race:​ uses double the bandwidth to avoid failsafes during bigger race events with many
pilots. ​ O nly use them in these scenarios!
To change the frequency band:
1. Power up your transmitter
2. Open the ​ C rossfire Transmitter​ menu
3. Navigate to the ​ G eneral ​ m enu
4. Change the ​ F requency ​ s etting according to your location
The frequency change is instant, and affects transmitter and receiver. It can even be changed in-flight if
necessary. If you change the frequency or region setting without the receiver being powered up you need
to rebind the receiver.
Region settings:
In the region settings, you can set your Crossfire according to your local laws. The region and the
frequency setting will disappear after this, as well as not allowed setting for this region. The Crossfire then
will limits the output power and the used the band according to the law and enables LBT (CE mode only)
Region setting Frequency
Open Not limited
CE 868 MHz, LBT technique
FCC 915 MHz
C-Tick 915 MHz
Max. power level Settings
locked
No limitations no
No limitations no
No limitations no
No limitations no
No limitations no
No limitations no
Max. power level Settings
locked
Not limited no
25mW yes
1W yes
1W yes
27