Detector Settings; Entering The Menu - Prosense PQ Series Installation And User Manual

Detector Settings

Prosense PQ detector prepared at factory to work as standalone detector. User may want to
change settings and alarm levels depending of the usage. PQD detector screen can be used to
change the detector settings. A magnet provided with detector to perform detector
configuration changes. The 3 keys on display will be used to perform any operation which are
Enter, up (Increase) and down (decrease). The Enter key needs longer touch (2 seconds) with
magnet while up and down keys can operate 1 second touch. If user wants to cancel any
operation on any screen keep magnet on Enter key till the screen return back to previous
screen.
PQN Series detectors will have same functions, options and screens when used with a hand
terminal. The hand terminal provided by Prosense and can be used to setup or maintain the

Entering the menu:

detector.
To reach configuration menu press Enter. The screen will request password information:
The password is 1234. You need to set values via using up and down keys. Once the value is
set press Enter again to confirm and move to the next digit. Confirmed digits will be made
invisible by detector program:
The screen will display menu options when correct password entered at last digit:
PRS-UM-PQ-EN-Rev.05-18.06.2020
PASSWORD
0
PASSWORD
****
1. Alarm Settings
2. Calibrate
3. Configure
4. Information
5. Test
6. Exit
26