Viewing Status Information And Resetting The Lamp Timer - Epson MovieMate 50 User Manual

You can adjust the following items:
■ Video Signal:
equipment. If no image appears or you see interference, select the appropriate signal.
■ Child Lock:
page 36 for more information.
■ Ceiling Projection:
ceiling. (Requires a special optional adapter.)
■ High Altitude Mode:
above 4,900 feet (1,500 meters), to ensure that MovieMate does not overheat.
■ Zoom:
the same as the
4. Press
5. Press

Viewing Status Information and Resetting the Lamp Timer

You can use the Info page on the Visual Setup menu to view the number of hours the lamp
has been used, and to reset the timer after you install a new lamp. You can also view video
signal information and error codes for any problems that occur.
1. Press
2. Press
information.
Note: If the lamp has been used less than 11 hours, 0H is displayed.
3. To reset the lamp timer after replacing the lamp, press
4. Press
40
Doing More with Epson MovieMate
Normally, you can leave this set to
Turn this setting on to lock the
Turn this setting on to invert the image for viewing on the
Turn this setting on if you use MovieMate at an altitude
Select to enlarge the image or
Wide
and arrows on the control panel.
W T
or to adjust the setting.
to exit the menu.
on the remote control. You see the Visual Setup menu.
to highlight , then press
Info
to exit.
when using external
Auto
button on the control panel. See
to reduce it. These settings work
Tele
to display the lamp usage and other
.