Frequency Set By Keypad And Run/Stop By External Source - LG SV008iS5-2 Manual

3.3.2

Frequency set by Keypad and Run/Stop by External Source.

1. Connect wiring as shown below.
P1 P2 P3 FX RX NC
JOG CM
CM BX
2. Apply AC power.
3. Confirm that the DRV 03 is set at 'Fx/Rx-1'.
4. Confirm that the DRV 04 is set at
'Keypad-1'.
Press SHIFT/ESC key.
5.
LCD: Press PROG key.
6.
7-Seg: Press PROG/ENT key.
LCD: Set the frequency using SHIFT/ESC
7.
and ▲ key.
7-Seg: Set the frequency by rotating the
encoder knob.
LCD: Press ENT key to save the data.
8.
7-Seg: Press PROG/ENT key to save the
data.
9. Close the FX or RX contact to run the
motor.
10. Open the FX or RX contact to stop the
motor.
VR VI
RST
I FM 5G
LCD Display
DRV►T/K 0.0 A
00 STP 0.00Hz
DRV► Drive mode
03 Fx/Rx-1
DRV► Freq mode
04 Keypad-1
DRV►T/K 0.0 A
00 STP 0.00Hz
DRV► Cmd. freq
00 0.00Hz
DRV► Cmd. freq
00 60.00Hz
DRV►T/V 0.0 A
00 STP 60.00Hz
The FWD or REV LED starts blinking. The RUN LED starts blinking.
The STOP/RESET LED starts blinking. The STOP/RESET LED starts blinking.
35
Chapter 3 - Quick Start Up
7-Segment Display
The DRV LED is ON.
The PROG/ENT LED is turned ON.
The PROG/ENT LED is turned ON.