LG SV008iS5-2 Manual page 148

When you want to use the auto tuning function
When you want to operate using PID feedback
When you want to change the reference frequency for acceleration and deceleration
When you want to change the acceleration and deceleration time scale
When you want to set the initial keypad display that is displayed when the power is turned ON
When you want to set the user defined display
When you want to adjust the gain for the motor RPM display
When you want to set the dynamic braking (DB) resistor mode
When you want to verify the inverter software version
When you want to change the connection from one motor to the other motor which use difference parameters
When you want to copy the inverter parameter to another inverter
When you want to initialize the parameters
When you want to prevent the parameters from being changed
I/O Group
When you want to set the analog voltage or current for the frequency reference
When you want to set the operating method when the frequency reference is lost
When you want to change the functions for the input terminals P1, P2, and P3
When you want to check the status of the input/output terminals
When you want to change the response time of the input terminals
When you want to use the JOG and multi step speed operation
When you want to change the 1
When you want to use the FM meter terminal output
When you want to set the frequency detection level
When you want to change the functions of the multi function auxiliary contact output (AXA-AXC)
When you want to exchange the motor to commercial power line from inverter or the opposite
When you want to use the fault relay (30A, 30B, 30C) functions
When you want to use RS232/485 communication
When you want to set the operating method when the frequency reference is lost
When you want to use the auto (sequence) operation
EXT Group (When a Sub-board and/or an option board is installed)
When you want to define the functions for the input terminals P4, P5, P6 (SUB-A, SUB-C)
When you want to use the analog voltage (V2) input (SUB-A, SUB-C)
When you want to use the encoder pulse for feedback to control the motor speed, or use the pulse input for
frequency reference (SUB-B)
When you want to change the functions of the output terminals Q1, Q2, Q3 (SUB-A, SUB-C)
When you want to use the LM meter terminal output (SUB-A, SUB-C)
When you want to use the analog outputs (AM1, AM2 terminals)
Intention
~ 7 acceleration/deceleration time
st th
85
Parameter Code
FU2-41 ~ 44
FU2-50 ~ 54
FU2-70
FU2-71
FU2-72
FU2-73
FU2-74
FU2-75 ~ 76
FU2-79
FU2-81 ~ 90
FU2-91 ~ 92
FU2-93
FU2-94
I/O-01 ~ 10
I/O-11
I/O-12 ~ 14
I/O-15 ~ 16
I/O-17
I/O-20 ~ 24
I/O-25 ~ 38
I/O-40 ~ 41
I/O-42 ~ 43
I/O-44
I/O-44
I/O-45
I/O-46 ~ 47
I/O-48 ~ 49
I/O-50 ~ 84
EXT-02 ~ 04
EXT-05 ~ 10
EXT-14 ~ 24
EXT-30 ~ 32
EXT-34 ~ 35
EXT-40 ~ 43