Operation Using Control Terminals - LG SV008iS5-2 Manual

3.2 Operation using Control Terminals

1. Install a potentiometer on terminals V1, VR,
5G and connect wiring as shown below.
P1 P2 P3 FX RX NC
JOG CM
CM BX
2. Apply AC power.
3. Confirm that the DRV 03 is set at 'Fx/Rx-1'.
LCD: Press ▲ key to move DRV 04.
4.
7-Seg: Rotate encoder knob until '04' is
displayed.
LCD: Press PROG key.
5.
7-Seg: Press PROG/ENT key.
LCD: Press ▲ key and set at 'V1'.
6.
7-Seg: Rotate encoder knob and set at '2'.
LCD: Press ENT key.
7.
7-Seg: Press PROG/ENT key.
Press SHIFT/ESC key.
8.
9. Set the frequency by rotating the
potentiometer.
10. Close the FX or RX contact to run the
motor.
11. Open the FX or RX contact to stop the
motor.
1 ㏀, 1/2 W
VR VI
RST
I FM 5G
LCD Display
DRV►T/K 0.0 A
00 STP 0.00Hz
DRV► Drive mode
03 Fx/Rx-1
DRV► Freq mode
04 Keypad-1
DRV► Freq mode
04 Keypad-1
DRV► Freq mode
04 V1
DRV► Freq mode
04 V1
DRV►T/V 0.0 A
00 STP 0.00Hz
DRV►T/V 0.0 A
00 STP 60.00Hz
The FWD or REV LED starts blinking.
The STOP/RESET LED starts blinking. The STOP/RESET LED starts blinking.
33
Chapter 3 - Quick Start Up
7-Segment Display
The DRV LED is ON.
The PROG/ENT LED is turned ON.
The PROG/ENT LED is turned ON.
The PROG/ENT LED is turned OFF.
The RUN LED starts blinking.