Operation Using Keypad - LG SV008iS5-2 Manual

3.1 Operation using Keypad

1. Apply AC power.
LCD: Press ▲ key three times.
2.
7-Seg: Rotate the encoder knob until '03' is
displayed.
LCD: Press PROG key.
3.
7-Seg: Press PROG/ENT key.
LCD: Press ▼ key one time.
4.
7-Seg: Rotate the encoder knob left.
LCD: Press PROG key.
5.
7-Seg: Press PROG/ENT key.
Press PROG/ENT key.
6.
LCD : Press PROG key.
7.
7-Seg : Press PROG/ENT key.
LCD: Press SHIFT/ESC key and press ▲
8.
key to increase the command frequency.
7-Seg: Rotate the encoder knob right to
change the command frequency.
digit moves by pressing the
LCD: Press ENT key to save the data.
9.
7-Seg: Press PROG/ENT key to save the
data.
10. LCD: Press FWD or REV key to start motor.
7-Seg: Press RUN key to start motor.
11. Press STOP/RESET key to stop motor.
The changing
SHIFT/ESC
key.
LCD Display
DRV►T/K 0.0 A
00 STP 0.00Hz
DRV► Drive mode
03 Fx/Rx-1
DRV► Drive mode
03 Fx/Rx-1
DRV► Drive mode
03 Keypad
DRV► Drive mode
03 Keypad
DRV►K/K 0.0 A
00 STP 0.00Hz
DRV► Cmd. freq
00 0.00Hz
DRV► Cmd. freq
00 60.00Hz
DRV►K/K 0.0 A
00 STP 60.00Hz
The FWD or REV LED starts blinking.
The STOP/RESET LED starts blinking. The STOP/RESET LED starts blinking.
32
Chapter 3 - Quick Start Up
7-Segment Display
The DRV LED is ON.
The DRV LED is turned ON.
The PROG/ENT LED turned ON.
The PROG/ENT LED is turned ON.
The PROG/ENT LED is turned ON.
The PROG/ENT LED is turned ON.
The RUN LED starts blinking.
To change the motor running
direction, change DRV 13 to '1'.