Available Data Area - Mitsubishi Electric Melsec WS Series User Manual

MELSEC-WS
Note
53
4.4.2

Available data area

This area offers all sources from which data may be routed into the network. It is
divided in two views holding the available Input types and Output data. You can
switch between these views using the file cards at the bottom.

The Input types view contains the input values for the connected MELSEC-WS
modules and EFI devices. If your MELSEC-WS safety controller contains a
second network module, the input data of this network module (i.e. data received
from the network the second network module is connected to) will be available
here as well.

The Output view offers the output values for the connected MELSEC-WS
modules and EFI devices as well as the Logic results from the logic editor.
All sources supported by the current configuration are displayed in black:

connected MELSEC-WS modules

connected EFI devices

configured logic results

input data available from another network module in the system
*1 In the default configuration, only the first logic result byte (Logic Result 0) is active and available. You
can activate more logic result output bits in the logic editor.
Sources currently not configured will be displayed in grey. Activating the Show only
available data checkbox in the upper left corner hides the unused sources from the
view.
Sources that offer "live" data are marked with a little icon next to the text.
How to add a data byte to the routing table:
 Drag and drop an element (i.e. byte) from the Available data area to a free slot
in the Network Module Data area. If the desired position is not free, you will
have to clear it first by deleting or moving the byte currently assigned to it.
It is possible to use the same byte several times in the routing table.
*1
Data sets