Mitsubishi Electric Melsec WS Series User Manual page 33

Ethernet interface module
Figure 15:
Connection settings
dialog with new TCP/IP
profile activated
Note
Note
 Click OK. All communication to the MELSEC-WS safety controller will now
happen via TCP/IP. In order to use the entry point via the serial interface again,
you will have to re-activate it.
The port number for the TCP/IP configuration interface is pre-set to port 9000 and
can not be changed.
Step 3: Connect via TCP/IP
 Click on the Connect button to go online.
While Setting and Monitoring Tool is connected via TCP/IP, do not transfer the
parameters in which the IP address of the connected Ethernet interface module has
been changed. Doing so will result in disconnection of communication. In that case,
click on the Disconnect button to go offline, make the correct configuration in the
Connection settings dialog, and then retry the connection.
MELSEC-WS
30