Ignition Control Led Service Codes; Section 11. Professional Service And Maintenance; Section 12. Spare Parts - Jandy JXi 200 Installation And Operation Manual

Page 42
ENGLISH

11.3 Ignition Control LED Service Codes

In addition to service diagnostic messages, the ignition controller has an LED light that flashes to indicate various
ignition control faults. The table below lists the LED codes and the corresponding fault description. To diagnose
possible cause and remedy, refer to
LED Code
The LED light is on
continuously.
LED single flash.
LED double flash.
LED triple flash.
Section 12. Professional Service and Maintenance
Call a qualified service technician to perform all service and repairs on the heater. To locate a licensed or qualified
technician or independent service company in your area, contact Zodiac Technical Support at:
1-800-822-7933
www.jandy.com
Before servicing the heater:
• Confirm that the heater control is set to either POOL or SPA
• Confirm the temperature set point for either Pool or Spa is set high enough to make the heater operate given the
current water temperature.
WARNING
SERVICING SAFETY
Service procedures can be hazardous because they involve fuel
gas, electricity, moving parts and procedures which require testing
or temporary bypass of safety controls. For this reason, the heater
must be serviced only by a qualified professional service technician.
IMPROPER SERVICE HAZARD
The heater incorporates unique design features. Incorrect service
of this heater can result in personal injury or damage to property. To
avoid such hazards, the heater must be serviced only by a qualified
professional service technician.
Section 13. Spare Parts
Using genuine Zodiac factory replacement parts helps to ensure the ongoing quality and reliability of our products.
Unauthentic parts might seem okay on the surface, but they often fall short of factory standards, and they typically
lack the backing you get from an established, global manufacturer like Zodiac. Plus, the use of unauthentic parts voids
all factory warranties.
Zodiac does not sell parts directly to pool owners, so when it's time for maintenance, please see your local Preferred
Professional Provider (PPP) of genuine parts. You can find a PPP at www.zodiacpoolsystems.com/parts.
NOTE: To identify the correct part, you will need to know the
model number, serial number and type of gas when applicable. This
information can be found on the rating plate sticker, which is located
inside the heater on the outside of the combustion chamber.
Section 10.2, Service Diagnostic Messages.
Fault Description
Ignition Control Fault. Refer to
qualified service personnel.
Air flow fault.
Flame exists when there is
NO call for heat. Refer to
qualified service personnel.
Ignition lockout (heater has
made three (3) unsuccessful
attempts to fire and is in a soft
lockout condition).
Jandy , JXi Gas-Fired Pool & Spa Heater
® ™
|
Installation & Operation Manual