Jandy JXi 200 Installation And Operation Manual page 10

Page 10
ENGLISH
4.2.1 Anchor Bracket Installation
Anchor brackets do not come standard with the JXi.
If you require the anchor brackets for your installation
please order kit #R0593400.
Anchor brackets should be installed in any circumstance
where the heater may be subject to natural risks such as
extreme weather or earthquake. In Florida, the heater is
required to be securely fastened to the equipment pad to
meet the applicable requirements of the Florida Building
Code. Other jurisdictions may have similar requirements
for extreme weather or other natural hazards. Check your
local codes for details.
a
Using an adjustable wrench or equivalent tool loosen (DO
NOT REMOVE) the retaining nut on the bracket. The upper
and lower anchor bracket should be able to rotate freely about
the retaining pin.
b
Slide the bracket into the slot located at the lower corner of
the heater base.
c
Rotate lower anchor bracket into final position. Ensure
that the lower anchor bracket is flush with the equipment pad
surface and level.
Anchor Bracket Upper
Retaining Nut
Retaining Pin
Anchor Bracket Lower
Concrete Equipment Pad
ANCHOR BRACKET INSTALLATION
SECTION VIEW
Jandy , JXi
® ™
assembly is secure.
hole as a guide. It is advised that a hammer drill with an
appropriate concrete drill bit be used.
bracket to the concrete pad. Do not over torque the screws.
JXi™ Heater Base
Anchor Bracket Slot
Concrete Screw
c
d
|
Gas-Fired Pool & Spa Heater
d
Tighten the retaining nut so that the anchor bracket
e
Drill a hole in the concrete using the lower anchor bracket
f
Place a screw in the hole and tighten to fasten the anchor
NOTE: Depending on the location of and access to the bracket, it
may be necessary to mark the drill location using the lower anchor
bracket hole as a guide. Remove the bracket from the heater, drill
the hole and then reattach the bracket to the heater base.
NOTE: Concrete screws are not provided in the anchor bracket kit.
Use size 1/4 in x 2-1/4 in galvanized or plated concrete screws and
washers.
a
e
Installation & Operation Manual
b
f