General; Authorized Inset - probst FTZ-I Operating Instructions Manual

General

2 General
2.1

Authorized inset

The FTZ-I is universal usable for gripping and moving customary prefabricated concrete products, with clean
gripping surface; like steps, kerbs (also natural kerbs), as well as "Kassler Bord" (Bus- and Train-profil-stones) and
so on. Connected with lifting equipment e.g. a excavator or a crane.
The FTZ-I is universal usable because of the great opening width and a high carrying capacity.
Look at the technical data list for details.
This device is series-produced equipped with
the following elements:
●
The opening range of the FTZ-I can be regulated universal over the spring bolt.
●
The FTZ-I is equipped with a automatic release to switching full automatically from "full onto empty" (grip and
to loosen of the gripping goods). That means the opening and closing of the gripper be caused through the
set down and the heave of the device.
ATTENTION: The use of this device is only permitted in proximity to the ground.
Only stone elements with parallel and plane surface are allowed to be picked-up and handled.
Because the gripping good could fall down.

universal adjustable opening range

suspension bolt for lifting tackle (crane-hook, belt
etc.) at support frame/lifting device

automatic release for the fully automatic switch over
from „full" to "empty" .

exchangeable rubber grippers
4 / 17