Table of Contents
Advertisement
40
REMOVING AND CARRYING THE OUTBOARD MOTOR
ENOM00070-D
1. Removing the outboard
motor
ENOW00064-0
Engine may be hot immediately after operat-
ing and could cause burns if touched. Allow
engine to cool down before attempting to
carry the outboard.
1
1. Cooling water check port
8
1. Before stopping the engine, close the
valve of the propane tank to consume
remained fuel in the fuel line. And
wait until engine is stopped.
2. Disconnect the fuel connector, the
remote control cables and the bat-
tery cords from the outboard motor.
3. Remove the outboard motor from
boat and completely drain the water
from the gear case in a vertical posi-
tion.
CAUTION
ENOF00437-2
ENOM00071-A
2. Carrying the outboard motor
ENOW00933-0
WARNING
Be sure to disconnect fuel connector except
when operating engine.
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00952-0
WARNING
When transporting, keep tank secured in
an upright position with the tank valve
turned off.
Do not use, store or transport tank where
it would be exposed to high tempera-
tures.
ENOW00066-C
CAUTION
Do not give a shock to an outboard motor
during transportation. It becames a cause
of breakage.
Do not carry or store outboard motor in
any of positions described below.
Otherwise, engine oil or cooling water
may enter the cylinder cause engine prob-
lems. Property damage could result from
leaking oil out.
ENOF01505-1
Advertisement
Table of Contents
