Table of Contents
Advertisement
36
ENGINE OPERATION
ENOM00920-A
6. Steering
ENOW00870-0
Sudden steering may cause passenger(s) to
be thrown overboard or falling down.
Tiller handle type
Right turn
Move the tiller handle to the left
7
Left turn
Move the tiller handle to the right.
ENOM00050-0
7. Trim angle
ENOW00043-A
Adjust the trim angle when the engine is
stopped.
Do not put hand or finger in between out-
board motor body and clamp bracket
ENOF00891-0
WARNING
ENOF00892-0
WARNING
when adjusting trim angle to prevent
injury in case the outboard motor body
falls.
Unsuitable trim position can cause loss of
control of boat. When testing a trim posi-
tion, run boat slow initially to see if it can
be controlled safely.
ENOW00044-0
WARNING
Excessive trim up or down may lead to unsta-
ble boat operation, potentially causing the
steering difficulty that leads to accident
during cruising.
Do not cruise at high speed if improper
trim position is suspected. Stop the boat
and readjust trim angle before continuing
cruise.
For outboard motor model with PTT
switch on the bottom cowl, do not oper-
ate the switch during cruising, or control
of boat may be lost.
The trim angle of the outboard motor can
be adjusted to suit the transom angle of
the hull, and load conditions. Choose an
appropriate trim angle that will allow the
anti-ventilation plate to run parallel to
the water surface during operation.
ENOM00052-0
Proper trim angle
The position of the thrust rod is correct if
the hull is horizontal during operation.
1. Perpendicular to the water surface
1
ENOF00051-1
Advertisement
Table of Contents
