Xerox 4050 Message Manual page 95

XEROX DOCUPRINT IPS MESSAGES GUIDE
F271 Chopped color DC bias voltage failure.
Indicates that the chopped color DC bias voltage is out of range.
Action Press the [Continue] button. If the error persists, contact your service
representative.
F272 Pretransfer shield voltage out of range.
The charge shield voltage is not within the required parameters.
Action Contact your service representative.
F273 Pretransfer dicorotron failure.
A pretransfer dicorotron error occurred.
Action Press the [Continue] button. If the error persists, contact your service
representative.
F274 Cleaner bias voltage 1 or 2 fault detected.
Cleaner bias voltage for either or both cleaner brushes is out of
range.
Action Press the [Continue] button. If the error persists, contact your service
representative.
F281 Photoreceptor servo drive fault detected.
A photoreceptor servo drive error occurred.
Action Press the [Continue] button. If the error persists, contact your service
representative.
F323 Unable to pass TAC calibration.
The TAC sensor did not pass the calibration test.
Action Press the [Continue] button. If the error persists, contact your service
representative.
H001 NVM failed power up test-battery functional test.
A nonvolatile memory (NVM) failure occurred.
Action Press the [Continue] button. If the error persists, contact your service
representative.
H002 NVM battery failure.
A nonvolatile memory (NVM) failure occurred.
Action Press the [Continue] button. If the error persists, contact your service
representative.
DOCUPRINT 4050, 4090, 4850, 4890, AND 92C IPS MESSAGES
3-23