Xerox 4050 Message Manual page 111

XEROX DOCUPRINT IPS MESSAGES GUIDE
P194 Input power to polygon driver board out of range.
The polygon driver board + 15V, -15V, or the -5.2 V voltage is not
within the acceptable range.
Action No action is required. If the error persists, contact your service
representative.
P195 Output power from polygon driver board out of range.
An error occurred in one or more motor driving signals.
Action No action is required. If the error persists, contact your service
representative.
P196 Enable line to polygon motor fault.
The motor enable signal is not on, or the motor is off.
Action No action is required. If the error persists, contact your service
representative.
P199 SOS scan board fault.
The SOS board was unavailable during a scan interval.
Action No action is required. If the error persists, contact your service
representative.
P200 Enable line to laser fault.
An error occurred in the enable line to the laser.
Action No action is required. If the error persists, contact your service
representative.
P201 Modulator fault.
The laser is turned off due to a modulator fault.
Action Contact your service representative.
P202 Laser Tube or Laser power supply failed.
The laser tube or the power supply to the laser failed. You cannot use
the machine until this problem is repaired by your service
representative.
Action Contact your service representative immediately.
P204 EOS scan board fault.
The EOS board was unavailable during a scan interval.
Action No action is required. If the error persists, contact your service
representative.
DOCUPRINT 4050, 4090, 4850, 4890, AND 92C IPS MESSAGES
3-39