Xerox 4050 Message Manual page 73

XEROX DOCUPRINT IPS MESSAGES GUIDE
3. 3DocuPrint 4050, 4090, 4850,
4890, and 92C IPS messages
This chapter contains a list, in alphabetical order by code, of the
messages that you may encounter while using your Xerox DocuPrint
4050, 4090, 4850, 4890, or 92C IPS.
Note: Throughout the messages in this section, '%s' denotes a file
name that will be supplied by the system when the message
displays.
C069 Paper tray 3 fault -- Select another tray.
An error or paper jam occurred in the elevator of input tray 3.
Action Open and close tray 3 and clear any jammed sheets. Retry the
operation. If the error persists, specify another tray for the job.
Contact your service representative for the tray 3 fault.
C070 Check paper supply in tray 3.
The paper supply is low in paper tray 3.
Action Add more paper to paper tray 3. Close paper tray 3 and press the
[Continue] button.
C071 Tray 3 wait station sensor not made, but SFRS made.
The paper did not arrive at the wait station sensor in time, or there
was no paper at the wait station when the feed was attempted.
Action Clear feeder tray 3. Close paper tray 3 and press the [Continue]
button.
C072 Sheet didn't clear tray 3 wait station sensor.
There is a paper jam in feeder tray 3. The sheet did not clear the tray
3 wait station sensor.
Action Clear the jam from feeder tray 3. Close paper tray 3 and press the
[Continue] button.
C073 Tray 3 feeder failed to feed sheet from stack to SFRS.
The feeder did not move a sheet from the stack to the stack force
relief sensor in time.
Action Clear feeder tray 3. Fan and add paper to tray 3. Close paper tray 3
and press the [Continue] button.
3-1