Xerox 4050 Message Manual page 24

DOCUPRINT 96/4635/180 IPS MESSAGES
2-12
03-390 UIM rigid disk fault.
A rigid disk failure was detected by the UIM Core board.
Action Select the Fault List icon on the printer control console touch screen.
Then touch the [Clear] button to clear the codes.
03-391 UIM rigid disk access fault.
A rigid disk access failure was detected by the UIM Core board.
Action Select the Fault List icon on the printer control console touch screen.
Then touch the [Clear] button to clear the codes.
03-392 Video engine rigid disk fault.
A rigid disk access failure was detected by the video engine board.
Action Select the Fault List icon on the printer control console touch screen.
Then touch the [Clear] button to clear the codes.
03-393 Video engine rigid access fault.
A rigid disk access failure was detected by the video engine board.
Action Select the Fault List icon on the printer control console touch screen.
Then touch the [Clear] button to clear the codes.
03-401 EDN system bus comm failure.
The bus communication to the EDN system is not responding. This
error is logged by the system.
Action No action required.
03-402 EDM comm problem with the UIM.
The EDM cannot communicate with the UIM.
Action Select the Fault List icon on the printer control console touch screen.
Then touch the [Clear] button to clear the codes. If the error persists,
check the shared lines. If the error still persists, contact your service
representative.
03-403 System comm problem with the MIN.
The system is temporarily unable to communicate with the MIN. This
error is logged by the system.
Action No action is required.
XEROX DOCUPRINT IPS MESSAGES GUIDE