Xerox 4050 Message Manual page 88

DOCUPRINT 4050, 4090, 4850, 4890, AND 92C IPS MESSAGES
3-16
F089 Purged prints in Sample tray and Sample tray was the selected
output.
The sample tray was specified for the job but contains purged sheets
that might be mixed in with your completed job.
Action Check the output delivered to the tray and remove any extra purged
sheets.
F090 Remove purged prints from purge output tray.
The purge tray contains purged sheets and may be full.
Action Empty the purge tray.
F122 Too few sheets in duplex tray.
The set separator activated the empty tray switch before the required
number of sheets was fed from the duplex tray. In general, this
indicates that a multifeed error occurred in the duplex tray.
Action Discard any unusable sheets and retry the operation. If the error
persists, contact your service representative.
F123 Duplex tray integrity fault with cycle down. (Too many/few
sheets)
A multifeed from the duplex tray has been detected.
Action Press the [Continue] button. If the error persists, contact your service
representative.
F127 Clean belt readings are out of range 120-250.
The photoreceptor belt may need to be replaced.
Action If trained to do so, replace the photoreceptor belt. Otherwise, press
the [Continue] button. If the error persists, contact your service
representative.
F135 IOT fails to rephase in 30 belt revolutions.
The registration mechanism (rephaser and belt) will not allow
rephasing to occur.
Action Press the [Continue] button. If the error persists, contact your service
representative.
F136 Check output -- image may be off paper.
An error occurred that may have caused the image to print out of the
page boundaries.
Action Verify the output for a printing error. If the output did not print
correctly, resubmit the job.
XEROX DOCUPRINT IPS MESSAGES GUIDE