Xerox 4050 Message Manual page 108

DOCUPRINT 4050, 4090, 4850, 4890, AND 92C IPS MESSAGES
3-36
L051 Paper width in Tray 1 changed within job.
The paper width required for the print job was changed in the middle
of the job and is not available in input tray 1.
Action Change the input configuration to specify the correct input tray for
this portion of the print job, or respecify the paper width within the
print job and resend the job. (Refer to the Xerox DocuPrint 4850/
4890 or 92C IPS Guide to Configuring and Managing the System for
the procedure.)
L052 Paper width in Tray 2 changed within job.
The paper width required for the print job was changed in the middle
of the job and is not available in input tray 2.
Action Change the input configuration to specify the correct input tray for
this portion of the print job, or respecify the paper width within the
print job and resend the job. (Refer to the Xerox DocuPrint 4850/
4890 or 92C IPS Guide to Configuring and Managing the System for
the procedure.)
L057 Paper in selected trays is not the same length.
The paper contained in the specified input trays does not match the
paper specified for the job.
Action Add the correct paper to the input trays, or change the input
configuration to specify the correct paper size for the job and press
the [Continue] button. (Refer to the Xerox DocuPrint 4850/4890 or
92C IPS Guide to Configuring and Managing the System for input
configuration procedures.)
L152 Stitcher is out of wire or the spool is not rotating.
The stitcher has run out of wire, or the wire spool is stuck.
Action If trained to do so, replace the wire in the stitcher and retry the
operation. Otherwise, contact your service representative.
L154 Stacker elevator tray full or not empty prior to size adjust or
stitch capacity reached.
Either the stacker tray is full, a previous job was not removed prior to
sending a new job, or the maximum number of stapled documents
has been reached.
Action Empty the output tray and press the [Continue] button.
L172 Stitcher is out of wire or wire not advancing.
The stitcher has run out of wire, or the wire is not feeding from the
spool.
Action If trained to do so, replace the wire in the stitcher and retry the
operation. Otherwise, contact your service representative.
XEROX DOCUPRINT IPS MESSAGES GUIDE