Flashforge Creator Pro User Manual page 35

Hide thumbs Also See for Creator Pro:

Table of Contents

Press page down key to select Right Extruder [or Left Extruder), press [OK] key, you will see:

Start Preheating

� Right Extruder

Left Extruder

Platform

Press page up key back to Start Preheat, and Press [OK] key, you will see:

Heating:

R Extruder: 33/230

L Extruder: 33/230

Platform : 024

(

This means the right extruder is heating up, when it reaches 22o·c. First push in the filament a little bit until

you see filament come out of the nozzle, press the spring presser then pull it out quickly. This will ensure

you have withdrawn the filament inside the nozzle successfully.

Then users should:

1. Insert your SO card with target x3g file to your Creator Pro ..

2. Turn on the Creator Pro.

3. Select [Print from SO] on the LCD panel.

4. Select the file you want to print and press [OK].

5.And the printer will heat up the nozzle and the build plate automatically and start to print after the

nozzle and the build plate reaches the aimed temperature.

OFF

(

Table of Contents

Need help?

Do you have a question about the Creator Pro and is the answer not in the manual?