Flashforge Creator Pro User Manual page 29

6.2.12 File Menus
1. Click [File)--[New Project) can build a blank project. If there is an unsaved
New Project:
modification needs to be saved or not. Click �sl
and then click [Nol
After finishing the model edit and adjustment, there are two ways below to save all
2. Saving:
models in the scene.
• Method 1: Click [File)--[Save Project) in the menu bar to save the file as a project file
WifflMW
Contains the outside shell value, capping layer value (under
vase mode, top solid layer setting is invalid.)
Perimeter Shells:
llp Solid Layers:
Bottom Solid Layers:
Fill
Fill Pattern:
Combine Infill:
according to the layer thickness. The combined thickness
should not exceed 0.4mm. "Every
while "Every
generally can save print time.
Wi@§,M
Print
the lower speed is, the better print you
80 is recommended.
l'avel Speed:
non-printing Status during work. For PLA printing, 100 is
recommended.
■
i§uj,j@\i'lij
Extruder Temperature:
is 220
in prints. Please adjust the temperature according to the
condition in order to get a good print.
Platform Temperature:
M%QM
Cooling Fan
fan. 'tlu can pre-set the height and make the cooling fan
begin to work at the point.
modification on previous project, then it will inform you whether the
will
cancel the new project.
the ".fpp" suffix, all models in the scene (include support) are
with
independent. If reloading the files, extruder configuration information and
model position will be the same as the configuration during saving.
Maximum is 10
Maximum is 30, minimum is 1.
Maximum is 30, minimum is 1.
Fill rata
Density:
The pattern of filling shape which effects printing
duration.
'lt!u can select the layers for combining
inner layers" is only for inner infills, which
N
Speed: The moving speed of the extruder. Generally,
Control the moving speed of the extruder under
Recommended extruder temperature
°
C. Different temperatures have subtle influences
Note:
Kl set the temperature of Platform.
Control: Set up the Ume to turn on the coollng
abandon it. If click [Cancel) or close tool tip, then it
69
layers" is for all the infills
N
get. For PLA printing,
will
save the modification,
will
will