Electronic Control
Control Condenser Fan Operation
The microprocessor observes the power output to both compressors; if power is being supplied to either compres-
sor, a signal is sent to the condenser fan relay on the control board to close, supplying power to the condenser fan
motor (See Figure 2-38). If both compressors are OFF, the condenser fan will be OFF.
1. Power output to
compressors
observed by
microprocessor
7040317 - Revision A - September, 2015
Built-In (BI) Series
Built-In (BI) Series
HIGH VOLTAGE
1 NEUTRAL
4 L1
6 L1
1 MAIN LIGHTS
3 COMP 1
5 COMP 2
8 DEFROST HTR
9
1
6
1
Figure 2-38. Signal Trace Schematic: Condenser Fan Operation
2. If power is supplied to
either compressor, the
condenser fan is energized
2-22
(SWS #4380000)
(SWS #4380000)
660 Ω
160 Ω
2300-2900 Ω
27.9-30.9 Ω