Commissioning; Adjusting The Spray Pattern - Krautzberger HS 25 Series Operating Instructions Manual

Hand-held Spray Gun HS 25
n The chemical consistency of the materials used by us cannot always be reliably assessed due
to the large variety of utilised fluids, concentrations, temperatures, and impurities. Note,
please test the suitability because we cannot extend any guarantees for that.
n Make sure that the utilised hose lines fulfil the requirements with respect to pressure, chem-
ical, and mechanical load.
n Never point the compressed air and the spray jet towards living beings.
6.3

Commissioning

Adhere to the operating instructions for the respective components.
1. Switch on the compressed air supply.
2. Where applicable, switch on pump or pressure container for spray fluid.
3. Point hand-held spray gun at a test surface.
Fig. 4: Pull lever
4. Begin spraying process by pulling the pull lever ( Fig. 4/1).
5. Adjust the spray pattern (
6. End spraying process by releasing the pull lever ( Fig. 4/1).
6.4

Adjusting the spray pattern

There are four different nozzle types:
Nozzle type
Round jet
Flat jet
Rotary jet
Full-cone rotary jet
HS 25, HS 25 HV1, HS 25 HV3
Ä Chapter 6.4 'Adjusting the spray pattern' on page 23).
Description
Cone-shaped stream in front of the
nozzle
Width-adjustable jet for flat-shaped
application
Rotary impulse creates heavily dis-
torted spray stream
Remark
-
A closed flat jet regulator creates
round jet
suitable for difficult work piece geo-
metries (angles, etc.)
ENGLISH
GB–23