General Information About The Operation - Krautzberger HS 25 Series Operating Instructions Manual

WARNING!
Vibrations caused by pulsation-generating compressor units!
Vibrations caused by pulsation-generating compressor units (pumps, compressors) can be
transferred to the spray gun via hose lines and lead to neurological or vascular disorders.
Note:
– Take breaks between spray processes.
– Use pulsation-dampening devices (pressure compensation container, etc.).
WARNING!
Vibrations caused by pulsation-generating compressor units!
Vibrations caused by pulsation-generating compressor units (pumps, compressors) can be
transferred to the spray gun via hose lines and lead to neurological or vascular disorders.
Note:
– Take breaks between spray processes.
– Use pulsation-dampening devices (pressure compensation container, etc.).
WARNING!
Hearing damage due to excessive noise exposure!
Depending on the operating conditions, the sound pressure of the device/machine may cause
hearing damage.
Note:
– Take suitable action to reduce the impact of the existing sound pressure level. The owner
is responsible for the type and implementation of suitable measures, which may depend
on the local conditions.
6.2

General information about the operation

Adhere to the following general information for the start of operation:
n Only carry out the installation and start of operation of the spray gun according to the steps
described in this operating manual.
n Check the material and compressed air hose lines before each use for damage and tight fit.
n Always observe the applicable country-specific safety, accident prevention, occupational
safety, and environmental protection regulations for the area of use for the spray gun.
n Adhere to the spray media manufacturer's safety data sheets.
n Only operate the spray gun while adhering to the values specified in the (
'Technical data' on page 51).
GB–22
Operating instructions
T-Dok-009-GB-Rev.3
Ä Chapter 13
mail@krautzberger.com, www.krautzberger.com