4.2
Commissioning
Observe the operating instructions for the components in question.
1.
Switch on the compressed air supply.
2.
Where applicable, switch on pump or pressure container for spray fluid.
3.
Point hand held spray gun at a test surface.
Fig. 4: Draw-off lever
4.
Begin spraying process by pulling the draw-off lever (Fig. 4/1).
5.
Adjust the spray pattern (
6.
End spraying process by releasing the draw-off lever (Fig. 4/1).
4.3
Adjusting the spray pattern
There are four different nozzle types:
Nozzle type
Round jet
Flat jet
Rotary jet
Full-cone rotary jet
GB–10
Operating instructions
Ä Chapter 4.3 „Adjusting the spray pattern" on page 10).
Description
cone-shaped stream in front of the
nozzle
width-adjustable jet for flat-shaped
application
due to rotary impulse strongly-dis-
torted spray stream
Remark
with closed flat jet regulator, a round
jet arises
suitable for difficult workpiece geo-
metries (angles, etc.)
mail@krautzberger.com, www.krautzberger.com
T-Dok-009-GB-Rev.0