Assembling The Shaft And Motor Cabling (536Lip4/530Ip4, 536Lipx/530Ipx) - Husqvarna 536LiP4 Workshop Manual

Repair instructions
8.9 Assembling the shaft and
motor cabling (536LiP4/530iP4,
536LiPX/530iPX)
1
Thread the cabling into the shaft, starting from the
saw head side.
2
Press the cabling into the connector. Make sure
the wings on both sides of the connector are pro-
truding slightly so they hook onto the sides of the
connector.
See figure 25.
3
Assemble the shaft in the battery housing using
the clamp and its screws.
See figure 26.
4
Assemble the connector in the control unit.
5
Assemble the shaft onto the saw head, 2 screws.
6
Couple the cables to a connector and couple the
connector to the motor.
Assemble the cable guard.
See figure 27.
7
Assemble the chain and bar as described in
"6.6 Chain and bar".
Fig 25
Fig 26
Fig 27
25 – English