Cleaning And Inspection Of The Main Switch - Husqvarna 536LiP4 Workshop Manual

For products with S/N: 20180200001- (LiPX/iPX),
20174600001- (LiP4/iP4), 20174600122- (LiPT5/
iPT5).
1
Dismantle the control handle as described in
"6 Basic dismantle/assembly".
2
Dismantle the throttle trigger lock and throttle
trigger as described in "7.1 Dismantling the throttle
trigger lock and throttle trigger".
3
Lift out the main switch and disconnect cable (A).
See figure 52.
4
To disconnect the cable (A), free the catch (D) with
a small screwdriver and pull the contact (C) out..
NB! Do not pull on the wires. Hold the contact
only when you pull it out.
See figure 53.
8.14 Cleaning and inspection of the
main switch
Clean and check the main switch. The main switch
must always be replaced with a new one if cracked
or showing signs of other defects.
Always use original spare parts.
See figure 54 for products with S/N: -20180200001
(LiPX), -20174600001 (LiP4), -20174600122 (LiPT5).
See figure 55 for products with S/N: 20180200001-
(LiPX/iPX), 20174600122- (LiP4/iP4),
20174600122- (LiPT5/iPT5).
Fig 52
C
Fig 53
Fig 54
Fig 55
32 – English
Repair instructions
A
D