Introduction And Safety Regulations; General; Safety; Target Group - Husqvarna 536LiP4 Workshop Manual

Introduction and safety regulations

1 Introduction and safety regulations

1.1 General

This Workshop Manual provides a comprehensive
description of how to troubleshoot, repair and test
the pole saw. A description of different safety steps
that must be taken during repair work is also given.

1.2 Safety

Note! The section dealing with safety must be
read and understood by all those carrying out
repair work or service on the pole saw.
Warning symbols can be found in this Workshop
Manual and on the pole saw. See "1.11 Symbols
on the pole saw" and "1.12 Symbols in the Work-
shop Manual". A new warning symbol decal must
be applied as soon as possible if a warning symbol
on the pole saw has been damaged or is missing
so that the greatest level of safety can be main-
tained when using the pole saw.

1.3 Target group

This Workshop Manual is written for personnel with
general knowledge about the repair and service of
trimmers.
The Workshop Manual must be read and under-
stood by personnel who will carry out repair work
and service on the pole saw. The Manual is also
suitable for use when training new employees.

1.4 Modifications

Any modifications to the pole saw will be gradually
introduced into ongoing production. As these mod-
ifications affect service and/or spare parts, specific
service information will be sent out on each occa-
sion. This means that in time this Workshop Manu-
al will become out of date. In order to prevent this,
the Manual should be read together with all service
information concerning the pole saw in question.

1.5 Tools

Special tools are required for some stages. All
service tools are listed in the Workshop Manual.
Usage is made evident in each section.
Always use original Husqvarna:
• Spare parts
• Service tools
• Accessories

1.6 Structure

This Workshop Manual can be used in two different
ways:
• For the repair of a particular system on the pole
saw.
• For the dismantling and assembling of the entire
pole saw.
Repair of a particular system
When a particular system on the pole saw is to be
repaired, proceed as follows:
1. Look up the page for the system in question.
2. Carry out the following steps:
• Dismantling
• Cleaning and inspection
• Assembling
Dismantling and assembling the entire pole
saw.
When taking apart the whole pole saw and putting
it back together again, proceed as follows:
1. Open the chapter "6 Basic dismantle/assembly"
and carry out Dismantling in the order set out in
the sections.
2. Open the chapter "8 Repair instructions" and
carry out Dismantling in the order set out in the
sections.
3. Carry out Cleaning and inspection in the order
set out in the sections.
4. Carry out Diagnostic troubleshooting if a fault
in the electrical system is suspected.
5. Order or collect all requisite spare parts from the
stores.
6. Carry out Assembly in the order set out in the
sections.

1.7 Numbering

Position references to components in the figures
are designated A, B, etc.
The figures are numbered 1, 2 etc.
The position references and figure numbers restart
in each new section.
3 – English