Husqvarna 536LiP4 Workshop Manual page 38

For products with S/N: 20180200001- (LiPX/iPX),
20174600001- (LiP4/iP4), 20174600122- (LiPT5/
iPT5).
1
Plug the connector into the main switch, place the
parts in the operating handle.
See figure 67.
2
Lay the cabling in place in the control handle. Make
sure that it is positioned outside (A) and inside (B).
Put the overmoulding behind (C) and the loose
cables in front of (C). Push the cabling all the way
down.
See figure 67.
NB! Make sure that no cables are in a position
where they don't get pinched or damaged when
the control handle is assembled.
3
Assemble the throttle trigger lock and throttle
trigger as described in "7.2 Assembling the throttle
trigger lock and throttle trigger".
4
Lay the cabling in place in the cable tray and as-
semble the control handle and battery housing as
described in "6 Basic dismantle/assembly".
Fig 66
B
A
Fig 67
38 – English
Repair Instructions
C