Changing The Emc Filter - Husqvarna 536LiP4 Workshop Manual

8.12 Changing the EMC filter

NB! Use the CST to check the functions before
dismantling.
Always replace a damaged EMC filter with a new
one.
1
Dismantle the battery housing as described in
"6 Basic dismantle/assembly".
Unplug the connector from the control unit.
2
Loosen the cables from the connector at the
battery housing end with a small flat screwdriver.
Make sure the wings on both sides of the
connector have been pressed in and then pull the
cable from the connector.
See figure 47.
3
Disconnect the wires (A, gray), (B, black) and (C,
red) from the motor and extract them from the EMC
filter.
See figure 48.
4
Thread the wires through the EMC filter (D).
NB! Thread the wires from the inside through
the EMC-filter twice.
Press the cabling into the connector with (A, gray)
at the top, followed by (B, black) in the middle and
(C, red) at the bottom.
See figure 48.
Make sure the wings on both sides of the connec-
tor are protruding slightly so they hook onto the
sides of the connector.
See figure 49.
5
Assemble the battery housing as described in
"6 Basic dismantle/assembly".
Fig 46B
Fig 47
A
B
C
Fig 48
Fig 49
30 – English
Repair instructions
D