Assembling The Motor - Husqvarna 536LiP4 Workshop Manual

11
Change the gasket between the motor and motor
housing.
See figure 8.
Cleaning and inspection
Clean and check the motor. The motor must always
be replaced with a new one if cracked or showing
signs of other defects. Always use original spare
parts.
8.3 Assembling the motor
1
Assemble the motor screws, 4 pcs, and assemble
the pump gear.
See figure 9.
2
Thread the cabling into the saw head.
Make sure the cables are positioned on the correct
side of the screw tower so the cables are not
pinched.
See figure 10.
Fig 8
Fig 9
Fig 10
20 – English
Repair instructions