Assembling The Shaft And Motor Cabling (536Lip4, 536Lipx) - Husqvarna 536LiP4 Workshop Manual

Repair instructions
9.9 Assembling the shaft and motor
cabling (536LiP4, 536LiPX)
1
Thread the cabling into the shaft, starting from the
saw head side.
2
Press the cabling into the connector. Make sure
the wings on both sides of the connector are pro-
truding slightly so they hook onto the sides of the
connector.
3
Assemble the shaft in the battery housing using
the clamp and its screws.
4
Assemble the connector in the control unit.
5
Assemble the shaft onto the saw head, 2 screws.
6
Couple the cables to a connector and couple the
connector to the motor.
Assemble the cable guard.
7
Assemble the chain and bar as described in
"7.6 Chain and bar" on page 22.
34 – English