Husqvarna 536LiP4 Workshop Manual page 21

Repair instructions
3
Couple the cables together.
See figure 11.
4
Assemble the cable holder on the motor (1).
Press the shaft (2) into the saw head to facilitate
assembly of the cabling. Screw finger tight (3).
See figure 12.
5
Couple the cabling together.
See figure 13.
6
Tighten the screws holding the saw head.
Fit the cable protector, 2 screws.
Tightening torque 6 ~ 8 Nm.
See figure 14.
Fig 11
2
Fig 12
Fig 13
Fig 14
21 – English
1
3