Assembling The Control Cabling - Husqvarna 536LiP4 Workshop Manual

Repair Instructions
8.18 Assembling the control unit -all
models
We recommend dismantling the control unit before
assembling the control cabling, see "8.19 Disman-
tling the control unit".
For products with S/N: -20180200001 (LiPX),
-20174600001 (LiP4), -20174600122 (LiPT5).
1
Connect the connector to the control unit. See
figure 64.
• Make sure that it snaps into place.
• Press the silicone gasket in place with your
fingers and make sure it fits tightly all around.
• Snap on the bracket holder.
NOTE! Do not use the bracket holder to
press the silicone gasket in place.
2
Place the bottom section of the cabling and the fan
in the battery housing.
Assemble the fan, making sure it is positioned in
the correct direction.
3
Assemble the keypad. Make sure the surface is
clean.
Connect the cable (A) to the position marked "B+"
on the main switch (C). Place the parts in the
operating handle. NB! Make sure to apply grease
to the contact surfaces and also the connector,
see service data.
See figure 65.
4
Lay the cabling in place in the control handle.
5
Assemble the throttle trigger lock and throttle
trigger as described in "7.2 Assembling the throttle
trigger lock and throttle trigger".
6
Lay the cabling in place in the cable tray and as-
semble the control handle and battery housing as
described in "6 Basic dismantle/assembly".
Fig 64
C
Fig 65
37 – English
B
A