Siemens SINAMICS G110M Manual page 16

3 Setting up and commissioning the application
3.5 Loading the software
No. Action
If the "Extended download"
16.
window appears, proceed as
follows:
Select "S7USB" as the type of
1.
the PG/PC interface and
"USB" as the PG/PC interface
to connect the SINAMICS
drive to the PG/PC via USB
cable.
2. Your SINAMICS drive is
displayed in "Compatible
devices in target subnet".
Acknowledge with the "Load"
3.
button.
Set the checkmark at "Save the
17.
parameterization in the EEPROM"
and start the download.
18. For the SINAMICS G120 you
perform a "POWER ON" (switch
off the voltage until all LEDs are
dark).
Simulation of the HMI KTP600 at the PG/PC (not applicable when device exists)
19. Set the PG/PC interface on
Windows level.
Select "S7ONLINE (STEP 7)" as
access point of the application
and our used network card
configured for TCP/IP as Interface
Parameter Assignment Used.
Navigate in Windows as follows:
>Start
> Control Panel
>Set PG/PC Interface
SINAMICS G120 DP at S7-1200
Entry-ID: 70155469, V1.4,
-
07/2018
Remarks
network card used
1
2
3
16