Ip And Pb Addresses; Pg/Pc Settings - Siemens SINAMICS G110M Manual

3 Setting up and commissioning the application

3.2 IP and PB addresses

3.2 IP and PB addresses
In the example the following IP and PROFIBUS addresses are used. The user can
make changes at any time.
Table 3-1: IP and PB addresses
Component
S7-CPU
G120
KTP600
PG/PC
The network mask of the IP network is always 255.255.255.0 and no router is
used.
3.3

PG/PC settings

To create a connection between the SIMATIC controller and your development
system (PG/PC), you need to assign a fixed IP address to the network card used in
the PG/PC for the application.
Table 3-2: Instruction – settings on PG/PC
Action
Assign a free, fixed IP address 192.168.0.x
to the network card used
(in this example: x = 252) and assign the
subnet mask 255.255.255.0.
In Windows 7, for example, you navigate as
follows:
>Start
> Control Panel
>Networks and Release Center
>Change adapter settings
>Right-click to the used network card
>Properties
>Internet protocol version 4 (TCP/IPv4)
>Properties
SINAMICS G120 DP at S7-1200
Entry-ID: 70155469, V1.4,
Device name
PLC_1
G120_1
HMI_1
- 192.168.0.200
07/2018
IP address DP address
192.168.0.1 1
- 3
192.168.0.3 -
-
Remarks
10