Table of Contents
Advertisement
Front Panel Features
A
TLI Pro 101 Front Panel
Figure 2.
A
Power LED — Lights green when the unit is powered on.
B
Menu button (recessed) — opens the
Press the button briefly (less than 2 seconds) to open the internal menu screens.
z
Press and hold the button (at least 2 seconds) to open the calibration screen. Follow the on-screen instructions to
z
calibrate the touchpanel.
Press the button briefly (less than 2 seconds) for a second time to close the current screen without saving any changes.
z
C
100 Mb network LED — Lights green when the unit is connected to a 100 Mb network.
D
Network link LED — Lights green when the unit is connected to any network.
E
Network activity LED — Blinks amber when there is activity on the network connection.
Reset Modes: a Brief Summary
The TLI Pro 101 offers the following reset modes:
Use factory firmware:
•
Reset All IP Settings:
•
Reset to Factory Defaults:
•
Setup Menu
Press the menu button (see
open the setup menu. Select any of the six available screens (
,
,
,
Network
Output
Audio
appropriate button in the navigation bar at the top of the screen.
Press the menu button for at least 2 seconds to open the calibration
screen. Follow the on-screen instructions.
setup menu
Press and hold the
mode to replace firmware in the event of firmware failure.
Press and hold the
twice, release and momentarily press the
settings without affecting user-loaded files.
Press and hold the
release and momentarily press the
factory default settings.
NOTES:
The factory configured passwords for all accounts on this device have been set to
•
the device serial number. Passwords are case sensitive.
If the device is reset to default settings, the password is the default password
•
configuration. The default password is extron.
Front Panel
Features,
B
, and
) by pressing the
Input
Advanced
TLI PRO 101
TOUCHLINK INTERFACE
C
100
MENU
LINK
ACT
B
E D
and
calibration screen
for the interface:
button (Figure 1,
G
) while applying power to the unit. Use this
Reset
button for 6 seconds. After the Reset LED (Figure 1,
Reset
Reset
button for 9 seconds. After the Reset LED flashes three times,
Reset
button. Use this mode to return the interface to
Reset
above) to
Status
,
Status
Info
Model:
Part Number:
Firmware
Version:
PoE Status:
Figure 3.
Product Category
button. Use this mode to reset all network
Audio
Input
Network
Output
Network
IP Address:
192.168.254.251
Resolution:
TLI Pro 101
DHCP:
Off
Project:
Host Name:
TLI-AB-CD-EF
Sleep Timer:
60-1083-01
1.00
Audio
On
Master Volume:
99
HDMI Port:
Master Mute:
Off
Advanced
Controller IP:
N/A
Project Size:
N/A
Setup Menu
F
) flashes
Advanced
Exit
Output
800x600
N/A
5 Minutes
Input
No Signal
3
Advertisement
Table of Contents
Need help?
Do you have a question about the TLI Pro 101 and is the answer not in the manual?
Questions and answers