Install Interior Trim - Master Bilt MCR-33101 Installation & Operation Instructions

1. If adjustment is necessary, all swing
doors have adjustable back-up plates in
the door for hinge adjustment.
2. Place shims under door.
3. Loosen but do not remove the screws
that attach the hinge blade to the door.
4. Shim under door as necessary to provide
a 1/4" space between top of door and the
doorframe to ensure square fit.
5. Tighten screws attaching the hinge blade
to the door.
6. After adjusting the hinges, remove shims
and check the space at the top of the
door for proper alignment.

INSTALL INTERIOR TRIM

-Install snap-on cover caps on the door panel cam locks.
-Use a level to plumb the evaporator and fan bank.
-Use the flange as a template to mark the screw hole placement with a marking pen to
make sure the evaporator and fan banks are installed plumb.
-Line drill through the holes in the flange using a 3/16" (#18) drill.
-Insert size 1/4" x 3/4" long self-threading screws (included).
-Fasten the fan bank and evaporator bank modules to the Blast Chiller interior as follows:
1. Install stainless steel trim pieces to the Blast Chiller interior above the fan and
evaporator banks.
2. This provides a neat finished appearance and promotes easy cleaning.
STEP 6
In this step you install the interior trim.
21