Table of Contents
Advertisement
NAP-200-002
Sheet 1/2
Marking and Drilling
1. CONFIRMING EQUIPMENT LAYOUT
Install the equipment in an area that provides adequate ventilation and is easily accessible to service personnel.
2. MARKING
Locate and mark the wall mounting points as shown in
30 mm (1.2 inch)
302 mm
(11.9 inch)
30 mm (1.2 inch)
ONE PIM CONFIGURATION
CHAPTER 3
Page 28
Revision 2.0
290 mm
ANCHOR (x4)
(11.6 inch)
354 mm
PIM
(13.9 inch)
350 mm
(13.8 inch)
PBX BOTTOM POSITION
Figure 002-1 Wall Mounting Points
Figure
002-1.
30 mm (1.2 inch)
302 mm
(11.9 inch)
30 mm (1.2 inch)
30 mm (1.2 inch)
302 mm
(11.9 inch)
30 mm (1.2 inch)
NDA-24219
209 mm
ANCHOR (x4)
(11.6 inch)
PIM
PIM
350 mm
ANCHOR (x4)
(13.8 inch)
TWO PIM CONFIGURATION
354 mm
(13.9 inch)
354 mm
(13.9 inch)
Advertisement
Table of Contents
