Example 1: Radar_Pulsed_Doppler_Led - Infineon XMC4700 Setup Manual

Using Infineon's radar baseboard XMC4700 and BGT24LTR11 radar
shield with Arduino
Set-up guide Software set-up
Figure 16 Accessing example sketches from this library
Table 4 Example sketches
Sketch name
Radar_Pulsed_Doppler
_LED
RadarPulsedDoppler
_Andee_RGB
3.4.1

Example 1: Radar_Pulsed_Doppler_LED

This section lists the steps to follow to get this example up and running.
1. In Arduino IDE, navigate to File > Examples > IFXRadarPulsedDoppler > Radar_Pulsed_Doppler_LED (as shown
previously in Figure 16). The sketch will open (Figure 17).
Required HW
Radar baseboard XMC4700 and BGT24LTR11 radar
shield
1) Radar baseboard XMC4700 and BGT24LTR11 radar
shield
2) Annikken Andee U shield
(https://www.annikken.com/andee-u)
3) RGB LED lighting shield with XMC1202
(https://www.infineon.com/cms/en/product/evaluation-
boards/kit_led_xmc1202_as_01/)
17 of 31
Description
Use on-board LED to
indicate detection of
motion and direction
of motion
Project and display the
results of radar
processing on a smart
device (e.g. cell
phone/tablet) via
Bluetooth, and at the
same time using an
external RGB LED to
indicate motion and
direction of motion
2019-12-02