Infineon XMC4700 Setup Manual page 23

Using Infineon's radar baseboard XMC4700 and BGT24LTR11 radar
shield with Arduino
Software set-up Set-up guide
Figure 28 Stacking the RGB LED lighting shield onto the radar baseboard XMC4700
Stack the Annikken Andee U shield onto the set-up (Figure 29). Notice that there are several jumper wires on
6.
the Annikken Andee U board. This is due to the hardware modifications required on the radar baseboard
regarding the ISCP header as mentioned in Section 2.3. Figure 30 illustrates the required connections.
Figure 29 Stacking the Annikken Andee U shield onto the set-up
23 of 31
2019-12-02