Iscp Header - Infineon XMC4700 Setup Manual

Using Infineon's radar baseboard XMC4700 and BGT24LTR11 radar
shield with Arduino
Hardware modifications Set-up guide
Figure 4 Jumper selection for IOREF
2.3

ISCP header

In case connection via the ISCP header is required to the target Arduino shield, do not use the pins from header
P7. Instead, connect the pins via jumper wires from the SPI pins on header P3 (Figure 5).
Figure 5 Use SPI pins on P3 instead of P7 (ISCP)
8 of 31
2019-12-02