Siemens Bently Nevada 3500 Proximitor Maintenance And Troubleshooting Manual page 19

Troubleshooting
6.3 System Event List Messages
This section describes the System Event List Messages that are entered by the
Proximitor/Seismic Monitor and gives an example of one.
Example of a System Event List Message:
Sequence
Number
0000000123
Sequence Number:
Event Information:
Event Number:
Class:
Event Date:
Event Time:
Event Specific:
Slot:
194
Event Event
Information Number
Device Not 32
Communicating
The number of the event in the System Event List (for
example 123).
The name of the event (for example Device Not
Communicating).
Identifies a specific event.
Used to display the severity of the event. The following
classes are available:
Class Value
0
1
2
3
The date the event occurred.
The time the event occurred.
It provides additional information for the events that use this
field.
Identifies the module that the event is associated with. If a
half-height module is installed in the upper slot or a full-
height module is installed, the field will be 0 to 15. If a half-
height module is installed in the lower slot, then the field will
be 0L to 15L. For example, a module installed in the lower
position in slot 5 would be 5L.
3500/42 Operation and Maintenance
Class Event Event
Date Time
DDMMYY
1 02/01/90 12:24:31:99
Classification
Severe/Fatal Event
Potential Problem Event
Typical logged Event
Reserved
Event Slot
Specific
5L