Advertisement
3.2.3.2
To install a spare full-height module
1. Ensure that the ejectors are in their normal position, flush with the front of the
module.
2. Slide the main module into place, ensuring that they are properly in the
guides provided on the floor and roof of the rack chassis.
3. Tighten the screws securely.
Application Advisory: It is important to tightly secure the thumb screws to
ensure each module is Chassis grounded. Loose thumb screws may allow noise
to show on the channel readings.
3.2.3.3
To add or remove a half-height card guide
Installing the card guide
Section 3 — Common maintenance procedures
Removing the card guide
25
Advertisement
Troubleshooting
