Table of Contents
Advertisement
Combi-Disc 4,5 – 5,5m
UK
20-06-2020
Replacement of wearing point
1
Before working with the machine's wearing points, the machine is to be fastened.
This can be performed by trestles under the main frame.
Dismount M12x50 mm bolt (Pos. 1) by means of 2 pcs. 19 mm spanners.
The
wearing point might fall off, when the bolt is removed – take care of foot and leg
injuries.
Dismount the wearing point by pushing it forward. This might be difficult due to
entrance of soil, and it might be a good idea to use a hammer.
2
Mount the new wearing point, item no. 645000044 (Pos. 2), by pushing the wearing
point to the rear and then in its place.
Check the M16 x 65 mm bolt for eventual damages and replace it as required, item no.
0235852+0272290+0264090
Mount the M16 x 65 mm bolt (Pos. 1), lubricate and tighten it with approx 20 Nm.
Be careful not to overtighten – the wearing point can be damaged
16
Back to the table of contents
Advertisement
Table of Contents
