Replacement Of Wearing Point; Scraper - HE-VA Sub-Tiller Series Operating Instructions, Declaration Of Conformity, Spare Parts List

Replacement of wearing point

Scraper

The Sub-Tiller has special designed scrapers among the
packer rings on the V-profile roller.
To avoid unnecessary wear and to obtain the best scraper
effect it is important to check the centering of the
scrapers every day.
Sub-Tiller 2.5 m / 3.0 m / 3.5 m / 4.0 m
1.
2. Dismount M16x65 mm bolt (Pos. 1) by means of 2 pcs. 24
1
3. Dismount the wearing point by pushing it forward. This
4. Mount the new wearing point, item no. 645000044 (Pos. 2),
5. Check the M16 x 65 mm bolt for eventual damages and
2
6. Mount the M16 x 65 mm bolt (Pos. 1), lubricate and tighten
7. Check that the breast wearing part of the wearing point is
Before working with the machine s wearing points, the
machine is to be fastened. This can be performed by trestles
under the main frame or by a support of the roller.
mm spanners. The wearing point might fall off, when the
bolt is removed take care of foot and leg injuries.
might be difficult due to entrance of soil, and it might be a
good idea to use a hammer.
by pushing the wearing point to the rear and then in its place.
replace it as required, item no. 690103190 + 690113008.
it with 197 Nm.
placed straight in front of the tine otherwise loosen the bolt
again (Pos. 1) and the wearing point is kept in its place while
the bolt (Pos. 1) is tightened again.
12
06/08 2007